110 punch block Patch#

It is vital that you should take care no to break the thin wire before it makes contact with the desired slot. You could just use a small flat-blade screwdriver as a substitute for a punch down tool. The process of punching down a wire properly takes a considerable amount of force. Though the blades for each type are pretty different, most punch down tools on the market today can accept both types. 110 BlockВ is most used for data network, although it is not absolutely so. The 110-block is now generic in usage and is a newer design by AT&T. The 66-block is mostly used in cross-connect blocks for voice cross-connects. Different blades are used depending on whether you are terminating 110 blocks or 66-blocks. To accommodate different connector types, there are punch down tools with 66, 110, BIX and krone blades. A punch-down tool is really just a handle with a special blade that fits a particular IDC. Most punch down tools are of the impact type, consisting of a handle, an internal spring mechanism, and a removable slotted blade.

Then the IDC connector makes contact by cutting through, or displacing, the insulations around a single conductor inside a twisted-pair cable. In the working process, the punch down tool punches down and force the Ethernet twisted-pair cable conductor into the V-shaped gap. IDC is a little knife blade with a V-shaped gap or slit between them.

110 punch block Patch#

It is used to terminate the Ethernet cables by inserting the cables wires into the insulation-displacement connectors (IDC) on the punch down blocks, patch panels, keystone modules, and surface mount of boxes. The punch down toolsВ can be also called a punchdown tool or a Krone punch down tool, which is a small hand tool used by the telecommunication and network technicians. These Ethernet cables usually need to be terminated with the keystone jacks, cross-connect blocks or patch panels. Copper networks are most built by the twisted-pair cables like the Cat5, Cat5e, Cat6 and some newer standard Ethernet cables. A punch down tool is commonly used for the termination works in the copper network.